Quick Start Guide ~ RCON PROFINET IO Specification ~
p2
©2023 / IAI Corporation
STEP
２
STEP
３
STEP
1
Table
of
Contents
This manual is a material created to make the startup work of the following RCON in the
PROFINET IO specification faster and simpler.
For details how to handle them, refer to [RCON Instruction Manual (ME0384)] provided
separately.
Also, explanations should be made with a system that each unit of RCON is linked
described as “RCON system”.
[RCON Subject in This Manual]
RCON-GW/GWG Gateway Unit
RCON-PC/PCF/AC/DC/SC Driver Unit
EC Connection Unit
SCON Extension Unit RCON-EXT
RCON Connection Type SCON-CB
Introduction
In this manual, explains an example of when ROBO Cylinder and ELECYLINDER
are connected to the RCON system about the contents in common for RCON /
“PROFINET IO” of R-Unit.
Also, for tool operations, it should be explained with IA-OS and Windows 10
for the PC OS environment.
●In this manual, with the case of the RCON system of IAI being connected
to an PROFINET port built in the PLC manufactured by Siemens（SIMATIC
S7-1200）as an example, explains the basic ways of implementing.
●The settings are subject to change in accordance with conditions and
purposes.
●The information contained in this manual is subject to change without
notice for the purpose of product improvement.
●If any issues arise regarding the information contained in this instruction
manual, contact our customer center or the nearest sales office.
● PROFINET is a trademark used under PROFIBUS Organization licenses.
● Simatic
®
is a registered trademark or trademark of Siemens Corporation,
Germany.
●The company names, names of products and trademarks of each company
shown in the text are registered trademarks.
To Next Page
Loading...
