IAI RCON Series - Check on Communication Status Among Each Unit in RCON System

Quick Start Guide ~ RCON PROFINET IO Specification ~
p57
©2023 / IAI Corporation
STEP
３
STEP
１
STEP
２
Initial Setting
Table
of
Contents
Panel
notation
Display
status
Definition of display
T RUN
Lit
Normal internal bus
communication
Blinking
Waiting for initialization
signal
Lit
Bus communication
error generated
SYS
Lit
Normal operation
Lit
Gateway alarm triggered
Confirm that the communication status is in normal by checking the LED lamps
(T.RUN and SYS) on the front of the gateway unit and each driver unit in the RCON
system.
Gateway unit side LED display
SYS
T.RUN
[LED status]
Communication
is normal
T.RUN
[LED status]
Communication
is normal
SCON side Fieldbus LED display
NS
MS
Gateway Unit
[LED status]
Communication
is normal
Panel
notation
Display
status
Definition of display
NS
Lit
Normal internal bus
communication
Blinking
Waiting for initialization
signal
Lit
Bus communication
error generated
MS
Lit
Normal operation
Lit
Gateway alarm triggered
T.RUN
24V Driver
Unit
200V Driver
Unit
SCON-CB-RC
Connection Specification
[LED status]
Communication
is normal
Check on Communication Status Among Each Unit
in RCON System
1
Checking Communication Status in RCON System
Panel
notation
Display
status
Definition of display
T RUN
Lit
Normal internal bus
communication
Blinking
Waiting for initialization
signal
Lit
Bus communication error
generated
Driver unit side LED display