IAI RCON Series

To Next Page

To Previous Page

Quick Start Guide ~ RCON PROFINET IO Specification ~

p56

STEP

３

STEP

１

STEP

２

Initial Setting

Table

Contents

“Information” window

This is necessary

for PLC setting!

Start up the “Gateway Parameter Setting” window again after the software

reset is completed.

* Refer to Launching IA-OS and Starting up Gateway Parameter

Window for how to make a startup.

(5)

As the “Gateway Parameter Setup Tool” window should be read in,

confirm that the contents which the parameters were changed are reflected.

Also, make a memo on the “Occupied size information” and “MAC

Address” in the red frame.

(6)

“Information” window

(4)

Click

“Information” window should open after the software reset is complete.

Click [OK] .

(4)

This completes the network setting of the RCON system.

Check the communication status between each unit.

IAI RCON Series - Page 56