IAI RCON Series - Operating Condition(AVD) and Stop Position Setting; Adjustment

Quick Start Guide ~ RCON PROFINET IO Specification ~
p112
©2023 / IAI Corporation
STEP
３
STEP
１
STEP
２
Operation
Table
of
Contents
1
Transferred Payload Setting
The stop position / operational conditions are set up in advance on delivery for
ELECYLINDER.
The operational conditions / stop position to be used can be tuned in the simple
data setting window.
Operating Condition (AVD) and Stop Position Setting /
Adjustment
There is a feature to calculate automatically the “optimum velocity and
optimum acceleration / deceleration” in ELECYLINDER.
Set the “Installation Posture” and “Transferred Payload” before setting or
adjusting the operating conditions.
●Make sure to touch Transfer after setting or adjusting the data (Icon: ).
●Switching the window without transferring should allow to get the data back.
Also, without transferring, operation with [Manual operation] button would
not work.
Click [Payload] in the “Simple data setting” window.
(1)
“Simple data setting” window
“Payload setting” window
(1)
Click
“Payload setting” window will be displayed.
(2)