IAI RCON Series - ２Operation from IA-OS (ELECYLINDER)

Quick Start Guide ~ RCON PROFINET IO Specification ~
p108
©2023 / IAI Corporation
STEP
３
STEP
１
STEP
２
Operation
Table
of
Contents
[Caution when Connecting ELECYLINDER]
●SIO connectors on ELECYLINDER side cannot be used during being connected
to the EC connection unit.
●When the mode switch on the gateway unit is set to AUTO, it should not be
available to go to the test run window of the digital speed controller for
ELECYLINDER.
●If the mode switch on the gateway unit gets switched from MANU to AUTO
during the test run window for the ELECYLINDER digital speed controller is
displayed, the test run window should close.
“IA-OS Main” window
Right-click [Axis No.4] in the status box in the “IA-OS main” window.
(1)
(1)
Right-click
Click [ps. data edit] .
(2)
(2)
Click
The “Simple data setting” window opens.
(3)
“IA-OS” Main window
“Simple data setting” window
Open the Position data editing window
1
2
Operation from IA-OS (ELECYLINDER)