IAI RCON Series - Wiring for 24 V Driver Unit

Quick Start Guide ~ RCON PROFINET IO Specification ~
p16
©2023 / IAI Corporation
STEP
３
STEP
１
STEP
２
Wiring
Table
of
Contents
Wiring for 24V Driver Unit
24V Driver unit /
Drive cutoff connector
Items to prepare
Insert a connector to the drive cutoff input and output part of the 24V
driver unit.
(1)
When it is not necessary to have the drive cutoff circuit on the 24V driver unit,
keep the short-circuit cables wired at delivery.
When it is necessary to have the drive cutoff circuit, perform wiring following
the procedures below.
(2)
(1) Prepare a cable with its diameter from
AWG 24 to 16.
(2) The strip length of a
cable should be 10mm.
(3) While pressing the
orange extruded part
with a slotted
screwdriver, insert a
cable at the inlet and
put it till it hits the end.
Wiring method to drive cutoff connector
GoodBad
(4) Release the slotted screwdriver.
5
Wiring to Drive Cutoff Connector on 24V Driver Unit
Tighten up
with slotted
screwdriver
RCON system
Drive Cutoff Connector
(Model: DFMC1.5/2-STF-3.5)
24V Driver Unit
(Model: RCON-PC-2)