IAI RCON Series - Transferring and Writing Parameters

Quick Start Guide ~ RCON PROFINET IO Specification ~
p55
©2023 / IAI Corporation
STEP
３
STEP
１
STEP
２
Initial Setting
Table
of
Contents
“Information” window
“Information” window should open after the transfer is complete. Click [OK] .
(3)
(3)
Click
“Check Process for Parameter Transfer” window
(2)
Click
Click [OK] in the “Check Process for Parameter Transfer” window.
(2)
“User parameter edit” window
Click [Tran] in the “User Parameter Edit” window.
(1)
(1)
Click
Transfer the edited parameter to a controller in the following procedures for operation.
Transferring and Writing Parameters