IAI RCON Series

To Next Page

To Previous Page

Quick Start Guide ~ RCON PROFINET IO Specification ~

p54

STEP

３

STEP

１

STEP

２

Initial Setting

Table

Contents

Special Parameter in RCON Gateway Unit: About MON Signal

Select “Special Parameters”

(1)

“User parameter edit” window

Click the tab in the User Parameter Edit window for the

gateway unit.

Select

Make sure that transfer of the parameters will be made. Without the transfer

of parameters, the setting would not be reflected.

Also, it is necessary to reboot the gateway unit after the data transfer.

“MON Signal” is a parameter to switch enable / disable commands sent from

PLC. Except for the EC connection unit, any command from PLC should not be

received unless MON Signal is on.

* It should be used only for control of driver units.

This parameter should be set to “0: Enable” on delivery.

By changing this to “1: Disable”, this parameter can be disabled.

Change the data.

(2)

Select “1: Disable” from the pulldown menu in the “MON Signal” box.

Click

(1)

Complement

IAI RCON Series - Page 54