Quick Start Guide ~ RCON PROFINET IO Specification ~
p25
©2023 / IAI Corporation
STEP
３
STEP
１
STEP
２
Wiring
Table
of
Contents
Actuator Connection Cable List
Complement
Refer to the table below for the model code of a cable to connect a 24V driver unit
and an actuator in the RCON system.
Note 1: Actuators using high-thrust pulse motor (56SP, 60P and 86P).
Note 2: The cable length from each driver unit to actuators should be 20m
at maximum regardless of the conversion unit. However, for the DC
brushless motor type, the maximum length from the driver unit
(RCON-DC) to RCD actuator should be 10m.
To Next Page
Loading...
