Quick Start Guide ~ RCON PROFINET IO Specification ~
p30
©2023 / IAI Corporation
STEP
３
STEP
１
STEP
２
Wiring
Table
of
Contents
Actuator Connection Cable List
Complement
Refer to the table below for the model code of a cable to connect a 200V driver unit
and an actuator in the RCON system.
Note 1: The cable length from each driver unit to an actuator should be 30m
at maximum.
Note 2: When it is required to operate an actuator equipped with a limit switch,
it should be the cable equipped with a limit switch.
(It has a limit switch built inside.)
Note 3: The cable length from each driver unit to an actuator should be 20m
for (1) to (4), (10) to (11), and 30m at maximum for others.
To Next Page
Loading...
