IAI RCON Series - Page 71

Quick Start Guide ~ RCON PROFINET IO Specification ~
p71
©2023 / IAI Corporation
STEP
３
STEP
１
STEP
２
Initial Setting
Table
of
Contents
Set up the PLC IP address. Input the “IP address” found in the “IP Protocol” area.
should be generated and
PROFINET Interface of “PLC_1” will be
connected.
Click found in the “Destination for Interface Network
Connection” in “Ethernet Address”.
“TIA Portal main” window
(7)
Click
PLC：IP Address
192.168.250.1
(8)
Input
“TIA Portal main” window
SIEMENS PLC
(7)
(8)