IAI RCON Series - Page 75

Quick Start Guide ~ RCON PROFINET IO Specification ~
p75
©2023 / IAI Corporation
STEP
３
STEP
１
STEP
２
Initial Setting
Table
of
Contents
4
Assigning PROFINET Unit
“TIA Portal main” window
(10)
Drag
&
Drop
Assign the IAI-PRT unit.
Drag & drop it from the PROFINET port of PLC_1 to the PROFINET port
of IAI-PRT.
“IAI-PRT” should get assigned to “PLC_1”.
(“Not Assigned” → Display changed to “PLC_1”)
In the same way, drag & drop it from the PROFINET port in PLC_1 to the
PROFINET port of IAI-PRT.
“TIA Portal main” window
“IAI-PRT” should get assigned to “PLC_1”.
“IAI-PRT” should get assigned to “PLC_1”.
(“Not Assigned” → Display changed to “PLC_1”)
REC system
RCON system
(2)
(1)
Drag
&
Drop