To Next Page

To Previous Page

Pre-3

Applicable Modes of IAI’s Industrial Robot

Machines meeting the following conditions are not classified as industrial robots according to Notice of Ministry

of Labor No. 51 and Notice of Ministry of Labor/Labor Standards Office Director (Ki-Hatsu No. 340):

(1) Single-axis robo with a motor wattage of 80 W or less

(2) Combined multi-axis robot whose X, Y and Z-axes are 300 mm or shorter and whose rotating part, if

any, has the maximum movement range of within 300 mm

including the tip of the rotating part

(3) Multi-joint robot whose movable radius and Z-axis are within 300 mm

Among the products featured in our catalogs, the following models are classified as industrial robots:

1. Single-axis ROBO Cylinders

RCS2/RCS2CR-SS8 whose stroke exceeds 300 mm

2. Single-axis robots

The following models whose stroke exceeds 300 mm and whose motor capacity also exceeds 80 W:

ISA/ISPA, ISDA/ISPDA, ISWA/ISPWA, IF, FS, NS

3. Linear servo actuators

All models whose stroke exceeds 300 mm

4. Cartesian robos

Any robot that uses at least one axis corresponding to one of the models specified in 1 to 3

5. IX SCARA robots

All models whose arm length exceeds 300 mm

(All models excluding IX-NNN1205/1505/1805/2515, NNW2515 and NNC1205/1505/1805/2515)

IAI ssel User Manual

Other manuals for IAI ssel