IBM P 615 series

Step 1549-6
Did the system stop with the same error code as recorded in “Step 1549-1” on page 125?
No The card just replaced was defective. This ends the procedure. Return the system to its original
configuration. Go to ″MAP 0410: Repair Checkout″ in the RS/6000 Eserver pSeries Diagnostic
Information for Multiple Bus Systems.
Yes
If all of the cards listed in “Step 1549-4” on page 126 have been replaced, go to “Step 1549-10.”
Otherwise, continue with “Step 1549-4” on page 126 and replacing the next card on the list.
Step 1549-7
Replace, one at a time the following cards (if present):
v First location code item recorded, if any, in “Step 1549-1” on page 125.
v Second location code item recorded, if any, in “Step 1549-1” on page 125.
v Third location code item recorded, if any, in “Step 1549-1” on page 125.
v Service processor card at U0.1-P1-X1, if not recorded in “Step 1549-1” on page 125.
Attention: Before replacing the system backplane, call support.
v CEC backplane at U0.1-P1, if not recorded in “Step 1549-1” on page 125.
Step 1549-8
Turn on the power.
Step 1549-9
Did the system stop with the same error code as recorded in “Step 1549-1” on page 125?
No The card just replaced was defective. This ends the procedure. Return the system to its original
configuration. Go to ″MAP 0410: Repair Checkout″ in the RS/6000 Eserver pSeries Diagnostic
Information for Multiple Bus Systems.
Yes
If all of the cards listed in “Step 1549-7” have been replaced, go to “Step 1549-10,” otherwise
continue with “Step 1549-7” and replacing the next card on the list.
Step 1549-10
Call support.
Chapter 3. Maintenance Analysis Procedures (MAPs) 127