IBM P 615 series User Manual

Table 2. Firmware Checkpoints (continued)
Checkpoint Description Action/
Possible Failing FRU
E170 Start of PCI Bus Probe Follow the repair action listed for
checkpoint E151.
E172 First pass of PCI device probe Follow the repair action listed for
checkpoint E151.
E174 Establishing host connection If the system is not connected to an active
network, or if the target server is
inaccessible (which can result from
incorrect IP parameters being specified),
the system still attempts to boot and
because time-out durations are necessarily
long to accommodate retries, the system
may appear to hang.
Restart the system and get to the SMS
utilities menu. Under Select Boot Options,
verify:
v Is the intended boot device correctly
specified in the boot list?
v Are the IP parameters correct?
v Look at the server configuration for this
client.
v Attempt to ping the target server using
the ping utility in SMS.
E175 BootP request Follow the repair actions for checkpoint
E174.
E176 TFTP file transfer Follow the repair actions for checkpoint
E174.
E177 Transfer failure due to TFTP error condition See “Boot Problems/Concerns” on page
155.
E17B Processor clock speed measurement Call service support.
E183 Service processor POST
1. Replace the service processor, location:
U0.1-P1-X1.
2. Go to “MAP 1540: Problem Isolation
Procedures” on page 110.
E18D A system reset request has been sent to
the service processor.
1. Check for system firmware updates.
2. Call service support.
E191 Create ISA reserved node Go to “MAP 1540: Problem Isolation
Procedures” on page 110.
E19A NVRAM auto-boot? variable not found -
assume FALSE
Go to “MAP 1540: Problem Isolation
Procedures” on page 110.
E19B NVRAM menu? variable not found -
assume FALSE
Go to “MAP 1540: Problem Isolation
Procedures” on page 110.
E19D Create NVRAM node Go to “MAP 1540: Problem Isolation
Procedures” on page 110.
E19E Real-time clock (RTC) initialization Refer to error code 28030xxx in
“Checkpoint and Error Code Index” on page
162.
142 EserverpSeries 615 Service Guide

IBM P 615 series Specifications

General

Brand	IBM
Model	P 615 series
Category	Server
Language	English