IBM P 615 series

Table 4. SPCN Error Codes for the CEC (system unit) (continued)
Error Code Description Action/
Possible Failing FRU
1011 2600 Pgood fault - power supply domain good Go to “MAP 1540: Problem Isolation Procedures”
on page 110.
1011 2603 Pgood fault - power supply domain bad Go to “MAP 1540: Problem Isolation Procedures”
on page 110.
1011 2612 Optical converter fault System backplane
Location: U0.1-P1
1011 2630 1.2v VRM fault VRM module
Location: U0.1-P1-V3
1011 2631 1.5v VRM fault System backplane
Location: U0.1-P1
1011 2632 1.8v VRM fault VRM module
Location: U0.1-P1-V1
1011 2633 2.5v VRM fault VRM module
Location: U0.1-P1-V2
1011 3100 I2C controller fault System backplane
Location: U0.1-P1
1011 3104 I2C bus 4 fault DASD backplane
Location:
U0.1-P2
DASD
backplane
Location:
U0.1-P3
Media backplane
Location:
U0.1-P4
Service
processor
Location:
U0.1-P1-X1
System
backplane
Location:
U0.1-P1
1011 3105 I2C interface fault System backplane
Location: U0.1-P1
1011 3106 I2C interface fault System backplane
Location: U0.1-P1
1011 3114 I2C interface fault System backplane
Location: U0.1-P1
1011 3116 I2C interface fault System backplane
Location: U0.1-P1
1011 3118 SPCN VPD collection fault System backplane
Location: U0.1-P1
1011 3119 DASD backplane fault DASD backplane
Location: U0.1-P2
1011 311A DASD backplane fault DASD backplane
Location: U0.1-P3
1011 311B Media backplane fault Media backplane
Location: U0.1-P4
1011 7610 System fan 1 fault Fan 1
Location:
U0.1-F1
1011 7611 System fan 1 missing Fan 1
Location:
U0.1-F1
1011 7616 Power supply 2 fan missing System drawer power supply 2
Location: U0.1-V2
168 EserverpSeries 615 Service Guide