IBM P 615 series User Manual

Table 5. Firmware Error Codes. (continued)
Error Code Description Action/
Possible Failing FRU
20EE 0020 The environment variable ″boot-device″ exceeds
the allowed character limit.
If this error occurs during the installation of AIX
by a ″NIM push″, the set_bootlist attribute may
not have been set correctly on the NIM master.
For more information, see the AIX 5.2
Installation Guide and Reference, order number
SC23-4389.
If this error occurs at any other time:
1. Check for platform firmware updates. Apply if
available.
2. Call service support.
20EE 0021 The environment variable ″boot-device″
contained more than five entries
If this error occurs during the installation of AIX
by a ″NIM push″, the set_bootlist attribute may
not have been set correctly on the NIM master.
For more information, see the AIX 5.2
Installation Guide and Reference, order number
SC23-4389.
If this error occurs at any other time:
1. Check for platform firmware updates. Apply if
available.
2. Call service support.
20EE 0022 The environment variable ″boot-device″
contained an entry that exceeded 255 characters
in length
If this error occurs during the installation of AIX
by a ″NIM push″, the set_bootlist attribute may
not have been set correctly on the NIM master.
For more information, see the AIX 5.2
Installation Guide and Reference, order number
SC23-4389.
If this error occurs at any other time:
1. Check for platform firmware updates. Apply if
available.
2. Call service support.
20EE 0100 Fcode resident on an I/O adapter is not
supported on this system
Informational message. The adapter’s Fcode
driver is not supported on this system. Additional
information may be available from service
support.
This error code only affects boot-time operation,
not the adapter’s functionality under the
operating system.
20FC 0020 Failed to retrieve power, packaging, and/or
cooling VPD via SPCN for the corresponding
subsystem. Service processor mailbox failed to
get VPD.
1. Check the RIO cabling.
2. Check for system firmware updates.
3. Replace the part specified by the location
code.
20FC 0021 Failed to retrieve power, packaging, and/or
cooling VPD via SPCN for the corresponding
subsystem. Service processor mailbox failed to
get power, packaging, and cooling device VPD.
1. Check the RIO cabling.
2. Check for system firmware updates.
3. Replace the part specified by the location
code.
178 EserverpSeries 615 Service Guide

IBM P 615 series Specifications

General

Brand	IBM
Model	P 615 series
Category	Server
Language	English