IBM P 615 series User Manual

Table 5. Firmware Error Codes. (continued)
Error Code Description Action/
Possible Failing FRU
20FC 0030 Corrupted power, packaging, and cooling device
VPD format in the SPCN configuration table.
1. Check for system firmware updates.
2. Replace the part specified by the location
code.
20FF 0001 Problem with VPD
1. Replace the part indicated by the location
code.
2. If no location code is specified, call service
support.
2100 0xxx SCSI controller fault
1. Before replacing any system components,
refer to the notes in error code 21A00001.
2. Replace the SCSI device.
2101 0010 The IDE device remained busy longer than
time-out period allows.
1. Retry the operation.
2. Check for system firmware updates.
3. Call service support.
2101 0011 Execution of the command by the IDE CD-ROM
was not completed within the allowed time.
1. Retry the operation.
2. The CD in the IDE CD-ROM may not be
readable. Try another CD.
2101 0012 Execution of the ATA command by the IDE
CD-ROM failed.
1. Check the power and signal connectors
going to the IDE CD-ROM.
2. Retry the operation.
3. The CD in the IDE CD-ROM may not be
readable. Try another CD.
2101 0013 Bootable media is missing from the IDE
CD-ROM
Put a bootable CD in the IDE CD-ROM drive.
2101 0014 The media in the IDE CD-ROM drive has been
changed
1. Retry the operation.
2. Check for system firmware updates.
3. Call service support
2101 0015 Packed command execution by the IDE
CD-ROM failed
1. The CD in the IDE CD-ROM may not be
readable. Try another CD.
2. Check for system firmware updates.
3. Call service support.
21A0 0001 Description: SCSI DASD - test unit ready failed - hardware error
Action:
Note:
1. Before replacing any system components:
a. Ensure that the controller and each device on the SCSI bus is assigned a unique SCSI ID.
b. Ensure SCSI bus is properly terminated.
c. Ensure SCSI signal and power cables are securely connected and not damaged.
2.
The location code information is required to identify the ID of SCSI device failures as well as to
indicate the location of the controller to which the device is attached. Check the system error
logs to determine the location code information associated with the error code.
a. Replace the SCSI device.
b. Replace the SCSI cable.
c. Replace the SCSI controller.
Chapter 5. Error Code to FRU Index 179

IBM P 615 series Specifications

General

Brand	IBM
Model	P 615 series
Category	Server
Language	English