IBM P 615 series

Table 5. Firmware Error Codes. (continued)
Error Code Description Action/
Possible Failing FRU
Memory Error Notes
Use the location code obtained from the SMS Error Log utility (described in “Error Log Utility Procedure” on page
200) to identify which memory DIMM (or memory DIMM quad) the error is reported against.
Memory error codes are in the form 25Cyyxxx where yy indicates memory DIMM present detect-bits (PD-bits) and
xxx indicates the last 3 digits of the error code.
See “Memory DIMM Present Detect Bits (PD-Bits)” on page 199 for information on how to interpret PD bits.
25B0 0001 No memory DIMMs detected. Go to “MAP 1240: Memory Problem Resolution”
on page 69.
25B0 0004 Multiple memory DIMMs failed a memory test. Go to “MAP 1240: Memory Problem Resolution”
on page 69.
25Cy y001 DIMM is not supported Replace unsupported DIMM(s).
Note: Memory DIMMs must be replace with a
supported type of memory DIMM. If an
unsupported type of memory DIMM is replaced
with the same unsupported type, the error
persists.
See the ″Memory Error Notes″ on page 184 for
more information.
25Cy y002 Memory DIMM fails memory test. Go to “MAP 1240: Memory Problem Resolution”
on page 69.
2602 0001 Description: Invalid PCI adapter vendor ID
Action:
1. Move adapter to another slot (behind a different PCI bus).
2. Check for available firmware updates for adapter. Apply update if available.
3. Run AIX diagnostics on adapter. Replace if indicated.
4. Replace adapter.
5. Check for system firmware updates. Apply if update available.
6. Replace the CEC backplane, location U0.1-P1.
2602 0002 Description: Invalid PCI adapter device ID
Action:
1. Move adapter to another slot (behind a different PCI bus).
2. Check for available firmware updates for adapter. Apply update if available.
3. Run AIX diagnostics on adapter. Replace if indicated.
4. Replace adapter.
5. Check for system firmware updates. Apply if update available.
6. Replace the CEC backplane, location U0.1-P1.
184 EserverpSeries 615 Service Guide