IBM P 615 series User Manual

1. Reset the system using the pin-hole reset button on the operator panel. Retry the operation
that caused this error code.
2. Check for a later level of firmware than the one that you were trying to install. Apply if
available.
3. Call service support.
9901:
State sequence error found during CRC query during firmware update.
Actions:
1. Reset the system using the pin-hole reset button on the operator panel. Retry the operation
that caused this error code.
2. Check for a later level of firmware than the one that you were trying to install. Apply if
available.
3. Call service support.
9902:
Mailbox LID data failure during firmware update.
Actions:
1. Reset the system using the pin-hole reset button on the operator panel. Retry the operation
that caused this error code.
2. Check for a later level of firmware than the one that you were trying to install. Apply if
available.
3. Call service support.
9903:
State sequence error found after a firmware update LID was received during firmware update.
Actions:
1. Reset the system using the pin-hole reset button on the operator panel. Retry the operation
that caused this error code.
2. Check for a later level of firmware than the one that you were trying to install. Apply if
available.
3. Call service support.
9904:
Error while flashing an update LID during firmware update.
Actions:
1. Reset the system using the pin-hole reset button on the operator panel. Retry the operation
that caused this error code.
2. Check for a later level of firmware than the one that you were trying to install. Apply if
available.
3. Call service support.
9905:
CRC mismatch after a firmware update LID was received during firmware update.
Actions:
1. Reset the system using the pin-hole reset button on the operator panel. Retry the operation
that caused this error code.
2. Check for a later level of firmware than the one that you were trying to install. Apply if
available.
3. Call service support.
9906:
Software problem during firmware update from operating system.
Actions:
1. Check for a system firmware update that is later than the one that caused this error. Apply if
available.
2. Call service support.
Chapter 5. Error Code to FRU Index 211

IBM P 615 series Specifications

General

Brand	IBM
Model	P 615 series
Category	Server
Language	English