IBM P 615 series User Manual

22. Remove the replacement adapter from the antistatic package.
Attention:
Avoid touching the components and gold-edge connectors on the adapter.
23. Place the adapter, component-side up, on a flat, static-protective surface.
24. Set any jumpers or switches as instructed by the adapter manufacturer.
25. Replace the adapter into the adapter slot. Carefully grasp the adapter by the edges and align the
adapter in the slot guides. Insert the adapter fully into the adapter slot connector.
26. If you are replacing or installing a short adapter, continue to the next step.
If you are replacing or installing a long adapter, do the following:
a. Close and latch the PCI adapter light-pipe plate attached to the fan tray.
b. Note the guide grooves located toward the front of the system in the disk drive backplane, and
align the adapter properly.
27.
Lower the plastic retaining seat over the PCI adapter faceplate (dotted lines). Rotate the locking latch
clockwise until it clicks into the locked position.
1
2
3
4
5
1 Model 6C3 or Model 6E3 4 Adapter Retainer Assembly (retainer seat
down and the locking latch in the locked
position)
2 Adapter Retainer Assembly (in the unlocked
position)
5 PCI adapter faceplate (dotted lines)
3 Adapter Retainer Assembly (retainer seat
down and the locking latch in the unlocked
position)
28. Connect appropriate cables and devices to the adapter.
29. Continue to follow the screen instructions until you receive a message that the replacement is
successful. Successful replacement is indicated by the OK message displayed next to the Command
field at the top of the screen.
30. Press F3 to return to the PCI Hot-Swap Manager menu.
Chapter 9. Removal and Replacement Procedures 303

IBM P 615 series Specifications

General

Brand	IBM
Model	P 615 series
Category	Server
Language	English