IBM P 615 series User Manual

13. Position yourself at the rear of the rack. Loosely thread one of the rail-retaining screws into the rail’s
rear screw hole. The screw hole is located between the two rear alignment pins. Return to the front of
the rack.
14. Attach the drawer latch bracket by doing the following:
a. Locate a drawer latch bracket and its screw.
b. Align the square peg on the back of the bracket with the square hole in the front rail assembly.
c. Place the hole in the bracket over the screw hole and loosely thread the screw into place. The
screw hole is located one position above the front rail-retaining screw.
15.
Before continuing to the next step, be sure to read and understand the following caution notices:
Attention: Mounting the rails is a complex procedure. To install the rack rails correctly, you must
read, and then perform each procedure step in the order given. Failure to perform each step in the
order given may cause rail failure.
CAUTION:
The stabilizer must be firmly attached to the bottom rear of the rack to prevent the rack from
turning over when the drawers are pulled out of the rack. Do not pull out or install any drawer
or feature if the stabilizer is not attached to the rack.
C17
CAUTION:
This unit weighs between 32 kg (70.5 pounds) and 55 kg (121.2 pounds). Three persons are
required to safely move it. Using less than three persons to move it can result in injury.
C05
Appendix D. Setting Up the System 413

IBM P 615 series Specifications

General

Brand	IBM
Model	P 615 series
Category	Server
Language	English