Table 3. Firmware Checkpoints (continued)
Checkpoint Description Action/ Possible Failing FRU
E135 Create memory DIMM node See the note on page136. When
performing MAP 1540, follow the
MAP steps to perform the system
rack minimum configuration.
E136 Test memory See the note on page136. When
performing MAP 1540, follow the
MAP steps to perform the system
rack minimum configuration.
E137 Create openprom node See the note on page136.
E138 Create options node See the note on page136.
E139 Create aliases node and system
aliases
See the note on page136. When
performing MAP 1540, follow the
MAP steps to perform the system
rack minimum configuration.
E13A Create packages node See the note on page136.
E140 Operating system load See the note on page136.
E149 Create boot mgr node See the note on page136.
E14C Create terminal-emulator node See the note on page136.
E14D Loading boot image See “Boot Problems” on page 155.
E14E Create client interface node/directory See the note on page136.
E14F NVRAM initialization See the note on page136.
E150 Create host (primary) PCI controller
node
See the note on page136.
E151 Probing primary PCI bus See the note on page136.
E152 Probing for adapter FCOD; evaluate
if present
See the note on page136.
E153 End adapter FCODE probe/evaluate See the note on page136.
E154 Create PCI bridge node See the note on page136.
E155 Probing PCI bridge secondary bus See the note on page136.
E156 Create PCI ethernet node See the note on page136.
E15A Create 64-bit host (primary) PCI
controller node
See the note on page136.
E15B Transferring control to operating
system (service mode boot)
See “Boot Problems” on page 155.
E15C Probe primary 64-bit MPIC bus See the note on page136.
E15D Create host PCI controller node See the note on page136.
E15E Create multi-processor IC node See the note on page136.
E15F Adapter VPD probe See the note on page136.
146 Service Guide
To Next Page
Loading...
