Table 5. Firmware Error Codes. (continued)
Error Code Description Action/ Possible Failing FRU
20EE0005 Invalid IP parameter (>255) Enter valid IP parameter.
Example: 255.192.002.000
20EE0006 No recognized SCSI adapter present This warning occurs when the selected
SMS function cannot locate any SCSI
adapter supported by the function. If a
supported SCSI adapter is installed:
1. Replace SCSI adapter(s).
2. Replace the I/O drawer planar in
drawer(s) containing SCSI
adapter(s).
20EE0007 Keyboard not found 1. Plug in keyboard.
2. Replace service processor card;
Location: U0.1-P1-X1.
20EE0008 No configurable adapters found in the
system
This warning occurs when the selected
SMS function cannot locate any
devices/adapters supported by the
function. If a supported device is
installed:
1. Replace the device or adapter. (See
notes on page 157.)
2. Replace the I/O drawer planar in the
drawer(s) containing the
device/adapter.
20EE0009 Unable to communicate with the service
processor
1. Replace the service processor card.
Location: U0.1-P1-X1.
2. Replace the I/O planar in primary
drawer
Location: U0.1-P1.
20EE000B The system was not able to find an
operating system on the device list that
was attempted.
Modify the boot sequence (also known
as boot list) to include devices that are
known to contain a copy of the
operating system. This can be
accomplished by using the system
management services menus. For
example, select a hard disk known to
have a copy of the operating system as
the first and only device in the boot
sequence (boot list) and attempt to boot
again.
162 Service Guide
To Next Page
Loading...
