Table 5. Firmware Error Codes. (continued)
Error Code Description Action/ Possible Failing FRU
28A00353 PS1 I2C bus hang. Firmware cannot
read the status of the first power supply.
1. Replace power supply 1.
2. Replace the power distribution
board.
3. Replace I/O drawer planar.
To identify failing I/O drawer location,
see note 5 on page 157.
28A00354 Drawer indicator panel I2C bus hang.
Firmware cannot read the status of the
drawer indicator panel.
1. Replace the drawer indicator panel
2. Replace I/O drawer planar.
To identify failing I/O drawer location,
see note 5 on page 157.
28A00355 PS2 I2C bus hang. Firmware cannot
read the status of the second power
supply.
1. Replace power supply 2.
2. Replace the power distribution
board.
3. Replace I/O drawer planar.
To identify failing I/O drawer location,
see note 5 on page 157.
29000002 Keyboard/Mouse controller failed
self-test
Replace the service processor card.
Location: U0.1-P1-X1.
29A00003 Keyboard not present/detected 1. Keyboard
2. Keyboard cable
3. Replace the service processor card.
Location: U0.1-P1-X1.
29A00004 Keyboard stuck key detected 1. Keyboard
2. Replace the service processor card.
Location: U0.1-P1-X1.
29B00004 Mouse not present/detected 1. Mouse
2. Replace the service processor card.
Location: U0.1-P1-X1.
2B2xxx11 Processor is manually disabled. Use the service processor menus to
re-enable the processor and reboot the
system.
2B200022 Processor is deconfigured by the
system.
Replace the processor card at the
location specified in the error log. See
note 5 on page 157 for location code
information related to this error.
2B2xxx31 Processor is failing POST Replace the processor card at the
location specified in the error log. See
note 5 on page 157 for location code
information related to this error.
Chapter 5. Error Code to FRU Index
173
To Next Page
Loading...
