Table 5. Firmware Error Codes. (continued)
Error Code Description Action/ Possible Failing FRU
2B200031 Processor is failing POST or is manually
disabled.
1. If the processor is not enabled, use
the service processor menus to
enable the processor. Then reboot
the system.
2. If the processor is failing POST,
replace the processor card at the
location specified in the error log.
See note 5 on page 157 for location
code information related to this error.
2B200042 Unknown processor card Remove the unknown processor card.
2BA00000 Service processor POST failure 1. Replace the service processor card;.
Location: U0.1-P1-X1.
2. Replace the I/O planar in primary
drawer.
Location: U0.1-P1.
2BA00012 Service processor reports self test
failure
1. Replace the service processor card;.
Location: U0.1-P1-X1.
2. Replace the I/O planar in primary
drawer.
Location: U0.1-P1.
2BA00013 Service processor reports bad NVRAM
CRC
If problem persists, replace service
processor card;.
Location: U0.1-P1-X1.
2BA00017 Service processor reports bad or low
battery.
1. Replace the system rack operator
panel battery.
Location: U1.1-P1-L1.
2. Replace the service processor card;.
Location: U0.1-P1-X1.
2BA00041 Service processor VPD is corrupted. Replace the service processor card;.
Location: U0.1-P1-X1.
2BA00071 VPD data corrupted for processor card
0
Replace the processor card. See note 5
on page 157 for location code
information related to this error.
2BA00072 VPD data corrupted for processor card
1
Replace the processor card. See note 5
on page 157 for location code
information related to this error.
2BA00073 VPD data corrupted for processor card
2
Replace the processor card. See note 5
on page 157 for location code
information related to this error.
174 Service Guide
To Next Page
Loading...
