Table 4. The following IP address information is required before initializing your system. Fill
in all the information needed in the Value column before proceeding with this
installation. (continued)
Field Value Notes
Internal IP address range The internal IP addresses are for
internal communication between the
file modules. Select one of the IP
address ranges listed below. The
available IP address ranges are:
1. 10.254.8.1, 10.254.8.2, 10.254.8.3,
10.254.8.10
2. 172.31.8.1, 172.31.8.2, 172.31.8.3,
172.31.8.10
3. 192.168.8.1, 192.168.8.2,
192.168.8.3, 192.168.8.10
Important: You must check carefully
that each of the IP addresses in the
range that you chose are not already
in use somewhere else in your
network. Refer to “Checking that IP
addresses are not already in use” on
page 11.
Storwize V7000 Unified
management IP address
Management IP address for the
Storwize V7000 Unified system. This
gives access to the management GUI
and CLI running on which ever file
module is currently the active
management node (such as
123.123.123.10)
File module 1 IP address The service access IP address
assigned to file module 1 (such as
123.123.123.11)
File module 2 IP address The service access IP address
assigned to file module 2 (such as
123.123.123.12)
Note: The Storwize V7000 service IP addresses are not set by the USB Initialize or
by the initial configuration done through the management GUI. Refer to “Step 25.
Next steps” on page 74 for how to set them.
Additional information must be ready before you start the initial configuration of
your system using the “Step 18. Configuring the system using the management
GUI” on page 67. Refer to “Information required before starting initial
configuration of your system.”
Information required before starting initial configuration of
your system
Identify the information needed to configure your system using the management
GUI.
Chapter 1. Before you begin the installation 15
To Next Page
Loading...
Need help?
General