Table 9. Authentication method information. Refer to the notes above
Field Value Note
Authentication
Method
[ ] Microsoft Active Directory (AD)
[ ] Lightweight Directory Access
Protocol (LDAP)
[ ] Samba Primary Domain Controller
(PDC) - NT4
[ ] None (requires configuring Network
information Service (NIS) for NFS
NetGroup support)
Check one of the options.
If you check None, do not select either of the
following NIS options.
Options
[ ] Kerberos, compatible with
authentication method of LDAP only
[ ] Services For UNIX (SFU) - compatible
with authentication method of AD only
[ ] Network Information Service (NIS) -
NFS NetGroup support without User ID
Mapping - compatible with
authentication method of AD or PDC
only.
[ ] Network Information Service (NIS) -
NFS NetGroup support authentication
method with User ID Mapping -
compatible with authentication method
of AD or PDC only.
One or more of these optional capabilities may
be used to extend the capabilities of the
authentication method selected previously. If
none of these options are needed then leave this
row blank.
If you checked Microsoft Active Directory in the Authentication Method field of
Table 9, then you must complete this table.
Table 10. Active Directory Configuration Information
Field Value Note
Active Directory
Server Ip Address
_____._____._____._____
_____._____._____._____
This is the numeric IP address of the remote
Active Directory server (domain controller) on
your network.
Active Directory
Userid
This is the user ID that must be provided when
communicating with the remote Active Directory
server. The following user ID and the password
are used to authenticate to the Active Directory
server.
Active Directory
Password
This is the password that must be provided
when communicating with the remote Active
Directory server.
22 Storwize V7000 Unified: Quick Installation Guide
To Next Page
Loading...
Need help?
General
