Table 5. This table can be used for recording the information needed for the initial configuration wizard in the
management GUI. The table entries serve as a guide only. Enter the Value column with your system
information. (continued)
Field Value Notes
CIDR equivalent of
the subnet mask
This is the CIDR (/XX) equivalent of the subnet mask
that was specified previously. Look up the subnet mask
(specified previously) then refer to the Table 8 on page
19 and find the CIDR equivalent and record it on this
line. It must be between /0 and /32 (for example, /24).
Default gateway IP
address
This is the numeric gateway IP address. It is used for
all network access to the file systems. For example,
99.99.99.1
Public IP addresses The public IP addresses are the data path connections
to your network. They are used for all of the Ethernet
data path connections the file modules. At least 2
addresses are recommended (1 per node). The data
path connections use Ethernet bonding, so a single IP
address (along with a subnet mask and gateway) is
used for all available Ethernet ports on a single file
module. The system automatically load balances
between the physical ports on a single file module.
(For example, 99.99.99.100,
99.99.99.101,99.99.99.102,99.99.103)
Additional public
gateway IP
addresses
Additional gateways IP addresses for access to the file
systems across each of the public networks.
Email server IP
address
The IP address of your email server for outgoing mail
(for example, 123.123.123.104)
Table 6. Information that the system will provide to IBM Remote Technical Support
Field Value Note
Company Name The name of your company
Address This is the address where the machines are
located. Example: Bldg. 123, Room 456, 789 N
Data Center Rd, City, State
Your Contact Phone
Number
This is the primary phone number that IBM
Remote Technical Support will call, if the system
calls home to report a problem.
Your Off Shift
Contact Phone
Number
This is the alternate phone number that IBM
Remote Technical Support will call, if the system
calls home to report a problem.
IP address of proxy
server (for call home)
_____._____._____._____
Optional. If a proxy server is needed to access
the internet for Call Home from the file modules,
this is the IP address of that server. If no proxy
server is used, leave this field blank.
Port Of Proxy Server
(For Call Home)
Optional. If a proxy server is needed, this is the
port corresponding to the IP address listed
previously. If no proxy server is used, leave this
field blank.
18 Storwize V7000 Unified: Quick Installation Guide
To Next Page
Loading...
Need help?
General
