IBM Storwize V7000 Unified Quick Installation Guide

3.
Note: If you are installing the slide rails into a 1U space with devices already
installed directly above and below this 1U space, you need to extend the slide
rails to slide the rear of the slide rails into the rear of the rack. When installing
a 2U device, be sure to install the slide rails in the bottom positon of the 2U
area in the rack.
From the front of the rack, line up the two pins on the rear of the slide rail in
the selected unit on the rear of the rack. Push the rails so that the pins go into
the holes and slide the rails into the rack to lock the rear of the slide rails into
the rack.
4. Push the blue button to allow the latch to slide forward. Then pull the slide rail
forward and locate the front latch in the appropriate unit space in front of the
rack EIA rail. Adjust the length of the rail.
ifs00021
Figure 21. Open the rear slide rail hooks.
ifs00022
Figure 22. Install the rear end of the slide rails.
Chapter 2. Performing the hardware installation 37

IBM Storwize V7000 Unified Specifications

General

Model	IBM Storwize V7000 Unified
Storage Type	Unified Storage
RAID Levels	RAID 0, 1, 5, 6, 10
Form Factor	2U
Drive Types Supported	SAS, SSD
Maximum Drives	504
Network Protocols	iSCSI, FC, FCoE
Drive Bays	24 per enclosure
Host Interface	8 Gb FC, 1 Gb/10 Gb iSCSI
File Protocols	NFS, CIFS
Block Protocols	iSCSI, Fibre Channel
Type	Unified Storage
Maximum Host Ports	16
Operating System Support	VMware, Microsoft Windows, Linux, AIX
Data Services	Thin provisioning, replication
Power Supply	Redundant power supplies
Host Interfaces	8 Gbps Fibre Channel, 10 Gbps iSCSI, 1 Gbps iSCSI