IBM Storwize V7000 Unified Quick Installation Guide

5. Press the blue button to release the bracket. Push the front latch in all the way.
Make sure the latch is fully engaged. Repeat steps 1 through 5 to install the
other rail into the rack. Make sure that each front latch is fully engaged.
Step 9. Installing the file modules
Install the file modules in the rack following the safety guidelines.
About this task
To install each file module in the rack, follow these instructions:
1. Pull the slide rails forward 1 until they click, two times, into place. Carefully
lift the file module and tilt it into position over the slide rails so that the rear
nail heads 2 on the device line up with the slide rails. Slide the file module
down until the rear nail heads slip into the two rear slots, and then slowly
lower the front of the file module 3 until the other nail heads slip into the
other slots on the slide rails.
ifs00023
Figure 23. Install the front end of the slide rails.
ifs00024
Figure 24. Install the front end of the slide rails.
38 Storwize V7000 Unified: Quick Installation Guide

IBM Storwize V7000 Unified Specifications

General

Model	IBM Storwize V7000 Unified
Storage Type	Unified Storage
RAID Levels	RAID 0, 1, 5, 6, 10
Form Factor	2U
Drive Types Supported	SAS, SSD
Maximum Drives	504
Network Protocols	iSCSI, FC, FCoE
Drive Bays	24 per enclosure
Host Interface	8 Gb FC, 1 Gb/10 Gb iSCSI
File Protocols	NFS, CIFS
Block Protocols	iSCSI, Fibre Channel
Type	Unified Storage
Maximum Host Ports	16
Operating System Support	VMware, Microsoft Windows, Linux, AIX
Data Services	Thin provisioning, replication
Power Supply	Redundant power supplies
Host Interfaces	8 Gbps Fibre Channel, 10 Gbps iSCSI, 1 Gbps iSCSI