8. Slide the file module into the rack until it snaps into place. To slide the file
module out of the rack, press on the release latches 1.
Note: When you move the rack cabinet, or if you install the rack cabinet in a
vibration-prone area, insert the M6 screws 2 in the front of the file module.
Step 10. Connecting the SAS cables to the expansion enclosures
Connect the SAS cables to the expansion enclosures.
About this task
This task applies if you are installing one or more expansion enclosures.
Note: The enclosure terminology that is used in this topic is described fully in
“Step 2. Identifying the hardware components” on page 3.
Be aware of these guidelines when you begin to attach the cables to the SAS ports:
ifs00031
Figure 31. Secure the cable management arm and the file module in the rack for shipping if
needed.
ifs00032
2
1
Storwize
V
7
0
0
0
U
n
if
ied
Storwize V7000 Unified
Figure 32. Install the front screws.
42 Storwize V7000 Unified: Quick Installation Guide
To Next Page
Loading...
Need help?
General
