10. Reconnect the power cord and any cables that you removed.
11. Replace the cover (see “Installing the cover” on page 174).
12. Turn on the peripheral devices and the server.
Note: When you restart the server, you are prompted to import the existing RAID
configuration to the new SAS/SATA adapter.
Removing an optional ServeRAID adapter advanced feature key
To remove an optional ServeRAID adapter advanced feature key, complete the
following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 167.
2. Turn off the server and peripheral devices and disconnect the power cords.
3. Remove the cover (see “Removing the cover” on page 174).
4. Grasp the feature key and lift to remove it from connector on the ServeRAID
adapter.
Chapter 5. Removing and replacing server components 205
To Next Page
Loading...
