IBM System x3550 M3 Type 4254 Problem Determination And Service Guide

4. Install the cover (see “Installing the cover” on page 174).
5. Slide the server into the rack.
6. Reconnect the power cords and any cables that you removed.
7. Turn on the peripheral devices and the server.
Removing and replacing FRUs
FRUs must be replaced or installed only by trained service technicians.
The illustrations in this document might differ slightly from the hardware.
Removing the 240 VA safety cover
To remove the 240 VA safety cover, complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 167.
2. Turn off the server and peripheral devices and disconnect all power cords; then,
remove the cover (see “Removing the cover” on page 174).
3. Remove the SAS/SATA riser-card assembly (see “Removing a PCI riser-card
assembly” on page 233).
4. Remove the screw from the safety cover.
242 IBM System x3550 M3 Types 4254 and 7944: Problem Determination and Service Guide

IBM System x3550 M3 Type 4254 Specifications

General

Brand	IBM
Model	System x3550 M3 Type 4254
Category	Server
Language	English