1. Read the safety information that begins on page vii and “Installation guidelines”
on page 167.
2. Turn off the server and peripheral devices and disconnect the power cords and
all external cables.
3. Align the cable connector with the connector on the rear of the optical drive
cage and press the cable connector into the optical drive cage connector until
it is firmly seated.
4. Pull the cable connector latch up and hold it there while you slide the cable
connector to the left; then, slide the cable connector latch down to lock the
cable in place.
The following shows cable routing for the DVD cable:
5. Reinstall the DVD drive (see “Installing an optional DVD drive” on page 190).
Chapter 5. Removing and replacing server components 231
To Next Page
Loading...
