CAUTION:
Never remove the cover on a power supply or any part that has the following
label attached.
Hazardous voltage, current, and energy levels are present inside any component
that has this label attached. There are no serviceable parts inside these
components. If you suspect a with one of these parts, contact a service
technician.
To install a hot-swap power supply, complete the following steps:
1. Read the safety information that begins “Safety” on page vii and “Installation
guidelines” on page 33.
2. Touch the static-protective package that contains the power supply to any
unpainted metal surface on the server; then, remove the power supply from the
package and place it on a static-protective surface.
3. If you are installing the power supply into an empty bay, remove the
power-supply filler panel from the power-supply bay.
4. Use one of the following procedures to install the power supply.
a. To install a 1400-watt power supply, complete the following steps:
1) Grasp the handle on the rear of the power supply and slide the power
supply forward into the power-supply bay until it clicks. Make sure that
the power supply connects firmly into the power-supply connector.
b. To install a 900-watt power supply, complete the following steps:
1) Insert the power-supply spacer into the left side (against the bay wall)
of the power-supply bay and slide it in until it snaps into place on tabs
on the side of the bay.
Chapter 2. Installing optional devices 97
To Next Page
Loading...
Need help?
General