Chapter 7. Management 215
6. Provide the authorized IDs of the personnel who need access to the service information
that is transmitted to IBM. This information is not a requirement to activate Service and
Support Manager. Click Next.
If you have not already created the IDs, you can do so by clicking the link, as shown in
Figure 7-20.
Figure 7-20 Authorize IBM IDs pane
7. Click Finish when done. You return to the Manage tab and the status of the Service and
Support Manager plug-in is now green.
The service will now actively monitor all eligible systems that are monitored by IBM Systems
Director.
See the IBM Systems Director 6.3.x Director SSM page which is available at this web page,
for further details regarding Service and Support Manager:
http://www.ibm.com/systems/software/director/ssm
Changing the location settings of a system
Perform these steps to change the location settings of a system:
1. Click Resource Explorer All Systems as seen in Figure 7-21.
Figure 7-21 Accessing Resource Explorer in IBM Systems Director
To Next Page
Loading...
