33
2. ADVANCED OPERATIONS
FM repeater operation
simultaneously retransmits them on a different
frequency to provide a greater communication range.
When using a repeater, the transmit frequency shifts
from the receive frequency by an offset amount. You
can access a repeater using the split function.
1. Set the operating frequency in the FM mode.
(Example: 29.650.00 MHz)
2. Hold down
for 1 second.
• Turns ON the Quick Split function.
• Turns the Tone function ON and “TONE” is displayed.
•
are displayed on the Sub band .
L You can set the frequency offset for the HF band.
Repeater Tone ON
frequency
Split function ON
Repeater Tone ON
» SET > Function > SPLIT >
FM SPLIT Offset (HF)
LYou can set the frequency offset for the 50 MHz.
» SET > Function > SPLIT >
FM SPLIT Offset (50M)
D Setting the repeater tone frequency
Some repeaters require a subaudible tone in order to
be accessed. Subaudible tones are superimposed on
Do the following steps to set the tone frequency.
1. Select the FM mode.
2. Touch [TONE] for 1 second.
3. Rotate
to select the subaudible tone
frequency.
Resets the tone frequency
to the default.
• Selectable tone frequencies
67.0 88.5 114.8 151.4 177.3 203.5 250.3
69.3 91.5 118.8 156.7 179.9 206.5 254.1
71.9 94.8 123.0 159.8 183.5 210.7
74.4 97.4 127.3 162.2 186.2 218.1
77.0 100.0 131.8 165.5 189.9 225.7
79.7 103.5 136.5 167.9 192.8 229.1
82.5 107.2 141.3 171.3 196.6 233.6
85.4 110.9 146.2 173.8 199.5 241.8
(Continued on the next page)
To Next Page
Loading...
