34
2. ADVANCED OPERATIONS
FM repeater operation (Continued)
Checking the repeater tone frequency
You can check the tone frequency by receiving the
receive the input signals, the transceiver detects
the subaudible tone frequency using the tone scan
function.
1. Touch [T-SCAN].
• The scan starts, and then stops when the tone
frequency on the repeater is received.
2. To close the TONE FREQUENCY screen, push
.
D Setting the repeater tone frequency (Continued)
Blinks while scanning
D Checking the repeater input signal
You can check whether you can directly receive
the repeater input frequency.
L While receiving, hold down
to listen the
repeater input frequency.
L While listening, the TX/RX indicator lights green,
and then the Noise Reduction and Notch Filter
settings are cancelled.
While holding
down
.
Release
.
Quick Split function ON
To Next Page
Loading...
