Icom IC-9100 - GPS out; Dvdat;Gps out Baud; RTTY Decode Baud; Calibration Marker

168
14
SET MODE
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
53"$!4!&UNC64. $EFAULT;'03=
Select the function of the [DATA1] jack.
s----- : The [DATA1] jack is not used.
s2449 5SEDTOSEND2449DECODEDSIGNALS
s$6DAT 5SEDFORLOWSPEEDDATAINPUTANDOUTPUT
s'03 5SEDFORTHE'03RECEIVERCONNECTIONFOR
position data input.
GPS Out 65. $EFAULT/&&
When a GPS receiver is connected to the [DATA1]
jack, the GPS position data is input through the jack.
9O U CANSELECTWHETHERORNOTTOSENDTHEDATAFROM
the COM port (“USB2”).
./4%9OUCANUSETHISFUNCTIONONLYWHENh-----”
or “DVdat” is selected as the “USB2/DATA1 Func”
(63) option, and “GPS” is selected as the “USB2/
DATA1 Func” (64) option.
s/&&  4URNSTHEFUNCTION/&&
s$!4! USB2 : Sends the GPS position data from
the COM port (“USB2”).
$6DAT'03/UT"AUD66. $EFAULT
Set the DV or GPS data transfer speed to 4800 or
9600 bps.
2449$ECODE"AUD67. $EFAULT
3ETTHE 2449DECODEMONITORSPEEDTO 
4800, 9600 or 19200 bps.
#ALIBRATION-ARKER68. $EFAULT/&&
Use as a simple frequency check of the transceiver.
See page 179 for calibration procedure.
./4% Turn OFF the calibration marker after check-
ing the frequency of the transceiver.
s/&&#ALIBRATIONMARKER/&&
s/. #ALIBRATIONMARKER/.
REF Adjust 69.
During frequency calibration, set the internal refer-
ENCEFREQUENCYTOBETWEENANDRANGEIN
steps.
./4% The default setting is different for each
transceiver.