124
9
GPS/GPS-A OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
D'03AUTOMATICTRANSMISSION
In the DV mode, this function automatically transmits
the GPS receiver’s current position data, at a selected
interval.
When a GPS message is programmed, the transceiver
transmits it along with the position data. See page 125
for the GPS message programming.
q Hold down [CALL/GPS] for 1 second to display the
“GPS” screen.
w Push [SET](F-5) to enter the GPS Set mode.
e Push [Y](F-1) or [Z](F-2) to select “GPS Auto TX.”
r Rotate [MAIN DIAL] to select the desired position
DATATRANSMITTINGINTERVALTOORSECONDS
3, 5, 10 or 30 minutes, or OFF.
* If four GPS sentences are selected in GPS Set mode on
page 122, “5 sec.” cannot be selected.
s4HE'03MESSAGEISALSOTRANSMITTEDIFPROGRAMMED
t Push [MENU] to save, and return to the “GPS”
screen.
./4%
s9OUROWNCALLSIGNMUSTBEENTEREDTOACTIVATETHE
GPS automatic transmission. (p. 93)
sUse GPS automatic transmission in only the sim-
plex mode.
s GPS automatic transmission through a repeater
may interfere with other communications.
q Hold down [CALL/GPS] for 1 second to display the
“GPS” screen.
w Push [POS](F-1), then push [F-2] once or twice to
display your own or the caller’s (other station) posi-
tion information.
s9O U CANNOT SAVE THE DATA ON THE h'0- 0OSITIONv
screen.
e Hold down [F-5] for 1 second to save the position
data to GPS memory (G00).
s4HE-EMORYCHANNELNUMBERADVANCESAUTOMATICALLYIF
the next Memory channel already contains information.
s'03-EMORYCHANNELAREAVAILABLE
D$ISPLAYTHE'RID,OCATORINFORMATION
The Grid Locator expresses the latitude and longitude
position data in a short string of characters. The IC-
9100 can display it on the LCD.
q Hold down [CALL/GPS] for 1 second to display the
“GPS” screen.
w Push [POS](F-1), then push [F-2] one or more times
to display the position information.
e While holding down [F-4], the grid locator informa-
tion is displayed.
To Next Page
Loading...
