Icom IC-9100 - Resetting the CPU

181
17
MAINTENANCE
N2ESETTINGTHE#05
D0ARTIALRESET
If you want to reset the operating parameters to their
default values (VFO frequency, VFO settings, menu
group’s contents) without clearing certain data as de-
scribed below, a partial reset can be performed.
The following data will not be cleared when doing a
Partial reset:
s-EMORYCONTENTS
s#ALLSIGNMEMORIES
s2EPEATERLISTS
s48MESSAGES
s'03MEMORIES
s'03MESSAGES
s-EMORYKEYERCONTENTS
s0ROGRAMMEDUSERBANDEDGEFREQUENCIES
s0ROGRAMMED!UTO2EPEATERFREQUENCYRANGES
s2%&!DJ2EFERENCEFREQUENCYSETTING
q First, turn OFF the transceiver power.
w While holding down [F-INP ENT] and [VFO/MEMO],
push [POWER] to turn ON the power.
s$URING STARTUP THE TRANSCEIVER DISPLAYS h0!24)!,
RESET,” then its initial VFO frequencies when resetting
is complete.
s)FYOUOPERATETHETRANSCEIVERBEFOREh0!24)!,2%3%4v
disappears, the resetting will be cancelled.
e If desired, edit the Set mode settings after reset-
ting.
D!LLRESET
The display may occasionally display erroneous infor-
mation (e.g. when first applying power). This may be
caused externally by static electricity or by other fac-
tors.
If this problem occurs, turn OFF the power. After wait-
ing a few seconds, turn ON the power again. If the
problem persists, perform the following procedure.
./4%Resetting the CPU CLEARS all programmed
contents and returns them to their default settings.
q First, turn OFF the transceiver power.
w While holding down [F-INP ENT] and [M-CLR],
push [POWER] to turn ON the power.
s$URINGSTARTUPTHETRANSCEIVERDISPLAYSh!,,#,%!2v
then when resetting is complete, then displays the initial
VFO frequencies.
s)FYOUOPERATETHETRANSCEIVERBEFOREh!,,#,%!2vDIS-
appears, the resetting will be cancelled.
e After resetting, edit the Set mode settings, if de-
sired.
[POWER]
[F-INP ENT] [M-CLR]
[POWER]
[F-INP ENT] [VFO/MEMO]