Icom IC-9100 - Communication Form; DR (D-STAR Repeater) Mode Operation

99
8
DV MODE OPERATION
DR (D-STAR Repeater) mode is used for D-STAR
repeater operation. In this mode, you can select the
pre-programmed repeaters and UR call sign by using
[MAIN DIAL].
s$2MODEOPERATIONmOWCHART
s2EPEATERSETTINGSCANBESTOREDINTOAREPEATERMEMORY
channel (Repeater list).
N $2$34!22EPEATERMODEOPERATION
3TEP2SELECTION
Select your access repeater.
- The Access repeater scan is useful to find a repeater.
3TEP52CALLSIGNSELECTION
Select your destination call sign
#ALLING#1
Through an access repeater
: CQCQCQ
Through a zone link repeater
or gateway repeater
: Zone link repeater or
Gateway repeater name
#ALLINGASPECIlCSTATION
3TEP2SELECTION
Select a zone link or gateway repeater.
If you make a call through an access
repeater, select “NOT USE1.”
Through an access repeater
: NOT USE1
Through a zone link repeater
: Zone link repeater name
Through a gateway repeater
: Gateway repeater name
Push PTT to transmit, release to receive.
Access/Area repeater (R1) selection
UR call sign (CQ) selection
UR call sign (specific station) selection
R2 (destination repeater) selection
GRP3
D1
R 1 :HIRANO43
CS CD R>CS UR DSET
CQ
CS CD R>CS UR DSET
D1
U R :CQCQCQ
UR
CS CD R>CS UR DSET
D1
U R :JG3YMK
CS CD R>CS UR DSET
D1
R 2 :NARA43
D#OMMUNICATION&ORM
s,OCALAREACALL(pp. 101, 103)
To c al l a s ta tio n thr ou gh yo u r lo c al ar ea (a cce ss ) r e-
peater.
s:ONECALL(pp. 102, 104)
To c al l a s ta tio n thr ou gh yo u r lo c al ar ea (a cce ss ) r e-
peater and a link repeater in the same zone.
s'ATEWAYCALL(pp. 102, 104)
To c al l a s ta tio n thr ou gh yo u r lo c al ar ea (a cce ss ) r e-
peater, gateway repeater and your destination repeater
by accessing the internet.
./4%
s Programming the repeater list is required for DR
mode operation. (pp. 89 to 92)
s9O U CANNOTMAKEAN)NTERNETCALLIFTHESELECTED
repeater (R2) has no gateway call sign.
s While operating voice communication or low-
speed data communication via the internet net-
work, some packets may be lost due to network
error (poor data throughput performance). In such
a case, the transceiver displays “ ” on the display
to indicate Packet Loss has occurred.