7
85
DV MODE PROGRAMMING
The optional UT-121 is required for DV mode opera-
tion.
N #ALLSIGNPROGRAMMING
&OURTYPESOFCALLSIGNSAREUSEDh-9vYOUROWNCALL
sign) “UR” (destination call sign, whether it is an indi-
vidual or a repeater.) “R1” (your access/area repeater
call sign) and “R2” (a destination or gateway repeater
call sign). Each call sign can be programmed with up
to 8 characters.
)NADDITIONYOUCANSTOREUPTOh-9vCALLSIGNSAND
up to 99 “UR” call signs in the call sign memory. Up to
500 repeater call signs can be stored in the repeater
list.
D h-9v9OUROWNCALLSIGNPROGRAMMING
9OUROWNCALLSIGNMUSTBEPROGRAMMEDFORBOTHDIGI-
tal voice and low-speed data communications (includ-
ing GPS transmission).
q Push [DVsDR] to select the DV mode.
w
P
ush [MENU] one or more times to display the “M3”
screen (Menu 3).
s)NTHE$2MODEP
ush [MENU] once or twice to select
the “D1” screen.
e
P
ush [CS](F-1) to display the “CS” screen (Call
Sign).
r
P
ush [Z](F-1) one or more times to display the h-9v
screen (-9CALLSIGNSETTING).
t2OTATE;-!).$)!,=TOSELECT-9OR
call sign memory.
y Push [EDT](F-3) to enter the call sign programming
mode.
s!CURSORAPPEARSANDBLINKS
u Rotate [MAIN DIAL] to select the first character to
input.
When inputting numbers, push the appropriate key-
pad key.
s0USH ;$%,=& TODELETE THESELECTED CHARACTER OR
number.
s0USH;30#=&TOINPUTASPACE
i Push [Ω](F-2) to move the cursor backwards, or
push [≈](F-3) to move the cursor forwards.
o Repeat steps u and i to enter your own call sign.
s!CALLSIGNOFUPTODIGITSCANBESET
s4O PROGRAMA NOTEUP TOCHARACTERS FOROPERATING
radio type, area, etc.), go to step !0, otherwise go to
step !2.
!0 Push [≈](F-3) to move the cursor right side of “/”.
!1 Repeat steps u and i to program the desired 4
character note.
!2 Push [MENU] to store the programmed call sign
and note.
!3 Push [MENU] again to return to the “CS” screen.
To Next Page
Loading...
