Icom IC-9100 - Memory Scan (Memory Mode); Mode Select Scan

150
11
SCANS
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
D-EMORYSCAN
A Memory scan searches for signals through Memory
channels 1 to 99.
Blank (unprogrammed) Memory channels are skipped.
./4% For a Memory scan to start, two or more
Memory channels must be programmed. (p. 140)
q Push [VFO/MEMO] to select the memory mode.
w P ush [MENU] to display the “M2” screen (Menu 2).
e P ush [SCAN](F-1) to display the “SCAN” screen.
r Set [RF/SQL] open or closed.
s4HESCANPERFORMANCEDIFFERSDEPENDINGONTHESQUELCH
setting when the scan was started. See page 146 for
details.
s)FTHE;2&31,=CONTROLFUNCTIONISSETTOh!54/vTHE
SQUELCH IS ALWAYS OPEN IN THE 33" #7 AND 2449
modes. (pp. 44, 162)
t Push [MEM](F-1) to start the Memory scan.
s4HE-(ZANDK(ZDECIMALPOINTSANDh-%-/3#!.v
blink while scanning.
s)F
“Up/Down” is selected as the “MAIN DIAL (SCAN)”
option
in the Scan Set mode, rotating [MAIN DIAL]
changes the scanning direction. (p. 147)
y Push [MEM](F-1) to cancel the scan.
N-EMORYSCAN-EMORYMODE
[SCAN]/[MEM] [VFO/MEMO]
[MENU][RF/SQL]
SCAN MEM SWR TCON VSC
M2
MEM
 F
SPAN SETSEL
SCAN
 F :  10k
MEM
∂ F
SPAN SETSEL
SCAN
MEMO SCAN
While Memory scanning
D-ODE3ELECTSCAN
Repeatedly scans all Memory channels with the same
operating mode as the displayed mode.
./4% For a Mode Select scan to start, two or more
Memory channels must be programmed, and their
operating mode must be the same as the displayed
mode.
q Follow steps q through r as described above.
w Hold down [MEM](F-1) for 1 second to turn ON the
Mode Select scan.
sh-/$%3vAPPEARS
e Push the mode switch to select the desired operat-
ing mode to be scanned.
r Push [MEM](F-1) to start the Mode Select scan.
s4HE -(Z AND K(Z DECIMAL POINTS ANDh-/$%3%,
SCAN” blink while scanning.
s)F
“Up/Down” is selected as the “MAIN DIAL (SCAN)”
option
in the Scan Set mode, rotating [MAIN DIAL]
changes the scanning direction. (p. 147)
s-EMORYSCANAND-ODE3ELECTSCANCANBESWITCHED
by holding down [MEM](F-1) for 1 second.
t Push [MEM](F-1) to cancel the scan.
While Mode Select scanning
Push
Push
MEM
∂ F
SPAN SETSEL
SCAN
MODE−SEL SCAN
[SCAN]/[MEM] [VFO/MEMO]
[MENU][RF/SQL] Mode switches