Icom IC-9100 - GPS Data Communication; Sentence Formatter Setting

122
9
GPS/GPS-A OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
D3ENTENCEFORMATTERSETTING
q Hold down [CALL/GPS] for 1 second to display the
“GPS” screen.
w Push [SET](F-5) to enter the GPS Set mode.
e Push [Y](F-1) or [Z](F-2) to select “GPS TX
Mode.”
r Rotate [MAIN DIAL] to select “GPS.”
s)Fh$ISABLEvORh'03!vISSELECTEDTHESENTENCEFORMAT-
ter items as described in step t will not appear.
t Push [Y](F-1) or [Z](F-2) to select the desired GPS
sentence.
s!TOTALOFSENTENCES2-#''!',,'3!64'AND
GSV are selectable.
y Rotate [MAIN DIAL] to turn the sentence ON or
OFF.
s(OLDDOWN;&=FORSECONDTORESETTOTHEDEFAULTSET-
ting, if desired.
u Repeat steps t and y to select another GPS sen-
tence.
s5PTOFOUR'03SENTENCESCANBESELECTED
i Push [MENU] to save, and return to the “GPS”
screen.
./4%
Set the GSV sentence to OFF when sending the
GPS message to conventional digital transceivers
(IC-2820H, IC-E2820, ID-800H, IC-91AD, IC-E91,
IC-V82, IC-U82, IC-2200H, ID-1).
The GSV sentence is incompatible with them. Those
transceivers will not display GPS messages properly
if a GSV sentence is sent from the IC-9100.
GPMPOS MSG SET
GPS
Push
[SET]
[CALL/GPS] [MAIN DIAL][MENU]
[][]
Ù 12 Ú GPS
SET GPS TX Mode
Ù 13 Ú ON
SET GPS Sentence (RMC)
Push
Select
DUPAGC AFC TON SCP
M1
Hold down
When RMC sentence usage is set to ON.
D'03DATACOMMUNICATION
The transceiver transmits GPS data or low-speed data
to the PC through the [DATA1] jack, depending on the
Set mode setting. (p. 168)
q Hold down [MENU] for 1 second to enter the Set
mode.
w Push [Y](F-1) or [Z](F-2) to select “USB2/DATA1
Func.” (64)
e Rotate [MAIN DIAL] to select “GPS” as the func-
tion of the [DATA1] jack to be used for position data
input.
r Push [MENU] to save, and exit the Set mode.
[MAIN DIAL][MENU]
[][]
Ù 64 Ú ––––– ⁄ [GPS ]
SET USB2⁄DATA1 Func
GPS (default)