Icom IC-9100 - 1750 Hz Tone Burst; One-Touch Repeater Function; Transmit Frequency Monitor Check

66
4
RECEIVE AND TRANSMIT
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
D/NETOUCHREPEATERFUNCTION
This function allows you to set the repeater operation
by holding down one switch.
First, set the frequency offset as well as the repeater
access tone frequency (p. 163).
q Select the desired frequency band. (p. 35)
w In the FM mode, p ush [A/B] to select VFO A.
e Rotate [MAIN DIAL] to set the desired receive fre-
quency (repeater output frequency).
r P ush [MENU] to display the “M1” screen (Menu 1).
t Hold down [DUP](F-2) for 1 second to turn ON the
One-touch repeater function.
sh4vANDh$50nvAPPEARS
s4HEREPEATERRECEIVEFREQUENCYAPPEARSONBOTTOMOF
the function display.
s4HE3PLITFREQUENCYOPERATIONISAUTOMATICALLYTURNED
OFF, if it is ON.
y Push [DUP](F-2) once or twice to switch the offset
direction.
sh$50nvORh$50vAPPEARS
u Communicate in the normal way.
DUPAGC AFC TON SCP
M1
M1
DUPAGC AFC TON SCP
145.92000
Appears Appears
Transmit (repeater receive)
frequency appears
Hold down
D4RANSMITFREQUENCYMONITORCHECK
9O U MAYBEABLETODIRECTLYRECEIVETHEOTHERPARTYS
transmitted signal without having to go through a re-
peater. This function helps you to check whether the
direct communication can be done, or not.
± While receiving, hold down [XFC] to see if you can
directly receive the other party’s transmitted signal.
s7HILEHOLDINGDOWN;8&#=THEOFFSETDIRECTIONANDFRE-
quency offset are displayed on the function display.
AGC DUP AFC TON SCP
M1
–600.0k
DUPAGC AFC TON SCP
145.92000
M1
[XFC]
Frequency Offset direction and value.
Hold down
D(ZTONEBURST
A 1750 Hz tone is required to access most European
repeaters.
± To transmit a 1750 Hz European repeater tone, hold
down [TON](F-4) during repeater operation. (p. 65)
sh4vBLINKS
./4%This function is not available for non-Euro-
pean versions.
M1
DUPAGC AFC TON SCP
145.92000
Blinks