Icom IC-9100 - Quick Tuning Function; Selecting Khz Step

38
3
BASIC OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
D1UICK4UNINGFUNCTION
The operating frequency can be changed in ‘kHz’ or
‘MHz’ steps for quick tuning.
Select the desired tuning step in each operating fre-
quency band and mode.
q Push [TS] to select the ‘kHz’ or ‘MHz’ Quick Tuning
function step, or turn it OFF.
s7HILETHEQUICKTUNINGICONhZ,” is displayed above the
1 kHz or 1 MHz digit, the frequency will be changed in
‘kHz’ or ‘MHz’ steps.
s7HENTHEFUNCTIONIS/&&THEFREQUENCYWILLBECHANGED
in 10 Hz steps.
w Rotate [MAIN DIAL] to change the frequency in the
selected steps.
./4%
s4OTURN/&&THE1UICK4UNINGFUNCTIONPUSH;43=
again. (“Z” disappears)
s7HENTHE1UICK4U NI N GFUNCTIONIS/&&THEFRE-
quency will be changed in 10 Hz steps.
D3ELECTING‘K(Z’STEP
When the ‘kHz’ quick tuning is selected, the frequency
can be changed in the selected ‘kHz’ steps.
The MAIN and SUB Bands use the common ‘kHz’ tun-
INGSTEP9OUCANSELECTITINBOTH"ANDS
q Push [TS] to turn ON the Quick Tuning function.
shZ” appears.
w Hold down [TS] for 1 second to display the “TS”
screen to select the quick tuning step.
e Select the desired operating mode.
r Rotate [MAIN DIAL] to select the desired ‘ kHz ’ step.
sANDK(ZARE
selectable.
s(OLDDOWN;&=FORSECONDTORETURNTOTHEDEFAULTSET-
ting, if desired.
t Repeat steps e and r to select quick tuning steps
for other modes.
y Push [TS] to exit the “TS” screen.
./4% To display the “TS” screen, the Quick Tuning
function must be turned ON first.
[TS]
[MAIN DIAL]
1kHz
SSB
TS
Appears
[TS][F-3]
Mode selection [MAIN DIAL]