s7HENCALLING#1THROUGHASINGLEREPEATER
q Select the desired frequency band. (p. 35)
w Push [VFO/MEMO] to select the VFO mode.
e Push [DVsDR] to select the DV mode.
r Set the repeater’s transmit frequency, duplex direc-
tion and offset. (pp. 37, 65, 163)
t
P
ush [MENU] one or more times to display the “M3”
screen (Menu 3).
y
P
ush [CS](F-1) to display the “CS” screen (Call
Sign).
u
P
ush [Z](F-1) to display the “UR” screen, and rotate
[MAIN DIAL] to select UR call sign, then push [SET]
(F-4).
s&IRSTSELECTINGTHECALLSIGNMEMORYGROUPSBYPUSHING
;43s'20=OR;'20=&MAKESITMORECONVENIENT
s When calling CQ : Select “CQCQCQ”
s When calling an individual station
: Select the station’s call sign
i
P
ush [Z](F-1) to display the “R1” screen, and rotate
[MAIN DIAL] to select the access repeater call sign,
then push [SET](F-4).
s&IRST SELECTING THE REPEATERCALL SIGNGROUP MAKES IT
more convenient, if you have programmed repeaters
into Groups. (p. 93)
s0USH;.!-%=&TOTOGGLETHECALLSIGNANDREPEATER
name display, if the name has been programmed.
o
P
ush [Z](F-1) to display the “R2” screen, and rotate
[MAIN DIAL] to set R2 to “NOT USE1,” then push
[SET](F-4).
!0
P
ush [Z](F-1) TODISPLAYh-9vANDSETYOUROWNCALL
sign if necessary, then push [SET](F-4).
!1 Push [PTT] on the microphone to transmit. (or
[TRANSMIT] on the transceiver)
s4HE-!)."AND4828INDICATORLIGHTSRED
!2 Release [PTT] to receive. (or push [TRANSMIT]
again)
s)FANOTHERSTATIONSREPLIESITSCALLSIGNWILLBESTOREDIN
the receive log.
s2ECEIVEDCALLSIGNSCANBEAUTOMATICALLYSTOREDINTOTHE
received call record. See page 95 for details.
After setting, rotate [M-CH] to select a memory
channel, then hold down [MW] for 1 second to save
this temporary programmed data into the channel.
To Next Page
Loading...
