Icom IC-9100 - 1;4 Tuning Step Function; Auto Tuning Step Function; Frequency Setting; Selecting 1 Hz Step

39
3
BASIC OPERATION
N Frequency setting (Continued)
D3ELECTING(ZSTEP
9OUCANCHANGETHEFREQUENCYIN(ZSTEPSFORFINE
tuning.
q Push [TS] to turn OFF the Quick Tuning function.
w Hold down [TS] for 1 second to turn the 1 Hz tuning
step ON or OFF.
./4%
s7HEN2)4ANDOR∂TX are used, they also tune in
1 Hz tuning steps.
s4HEFREQUENCYCHANGESIN(ZSTEPSWHENTHE
[UP]/[DN] switches of the microphone are used
for frequency tuning (if the quick tuning function is
not selected.)
D!UTOTUNINGSTEPFUNCTION
When you rotate [MAIN DIAL] rapidly, the tuning speed
can automatically accelerate, depending on the “MAIN
DIAL Auto TS” option in the Set mode.
q Hold down [MENU] for 1 second to enter the Set
mode.
w Push [Y](F-1) or [Z](F-2) to select “MAIN DIAL
Auto TS.”
e Rotate [MAIN DIAL] to select the HIGH or LOW
tuning speed acceleration, or to turn OFF the func-
tion.
s()'(7HENTHE TUNINGSTEPIS SET TO K(ZOR
smaller steps, the tuning speed is approxi-
mately five times faster.
When the tuning step is set to 5 kHz or
larger steps, the tuning speed is approxi-
mately two times faster.
(default)
s,/7!PPROXIMATELYTWOTIMESFASTER
s/&& !UTOTUNINGSTEPISTURNED/&&
s(OLDDOWN;#,2=&FORSECONDTORESETTOTHEDE-
fault value.
r Push [MENU] to save, and exit the Set mode.
D
1
⁄4TUNINGSTEPFUNCTION
-ODE33"$#72449
The dial speed is reduced to
1
⁄4 of the normal speed
when the
1
⁄4 tuning function is ON, for finer tuning con-
trol.
9O U CANSETTHE
1
⁄4 tuning function in each operating
frequency band.
This function is selectable only when the quick tuning
function is turned OFF.
q Push [MENU] to display the “M1” screen (menu 1).
w Push [1⁄4](F-3) to turn the
1
⁄4 tuning function ON or
OFF.
sh ” appears when the
1
⁄4 tuning function is ON.
[TS]
[MAIN DIAL]
AGC DUP COMP TBW SCP
M1
1 Hz step indication
[][]
[MAIN DIAL][MENU]
HIGH (default)
Ù 44 Ú HIGH
SET MAIN DIAL Auto TS
[1⁄4]
[MENU]
AGC DUP 1/4 SCP
M1
Appears